64
EN
USING THE REMOTE CONTROL UNIT
(cont.)
Insert Editing
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in and
outpoints. The original audio remains unchanged.
NOTES:
●
Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen
(
墌
pg. 49, 51).
●
Insert Editing is not possible on a tape recorded in the
LP mode or on a blank portion of a tape.
●
To perform Insert Editing while watching in the
television, make connections (
墌
pg. 22).
1
Play back the tape, locate the Edit-Out point and
press
PAUSE
(
6
). Confirm the time code at this point
(
墌
pg. 49, 51).
2
Press
REW
(
2
) until the Edit-In point is located,
then press
PAUSE
(
6
).
3
Press and hold
INSERT
(
w
) on the remote
control, then press
PAUSE
(
6
). “
6w
” and the Time
Code (min.:sec.) appear and the camcorder enters
Insert-Pause mode.
4
Press
START/STOP
to begin editing.
• Confirm the insert at the time code you checked in
step
1
.
• To pause editing, press
START/STOP
. Press it again
to resume editing.
5
To end Insert Editing, press
START/STOP
, then
STOP
(
5
).
NOTES:
●
Programme AE with special effects (
墌
pg. 38, 39) can
be used to spice up the scenes being edited during
Insert Editing.
●
During Insert Editing, the date and time information
changes.
●
If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
●
During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert
Edting stops (
墌
pg. 86).
w
6
12 : 3 4
PLAY
PAUSE
INSERT
REW
START/STOP
STOP
Power Switch
Display
Remote sensor
Lock Button
