8
Remote Control Function
(Refer to page 7)
Remote Control A/B/C/D Code Switching
The remote control is capable of controlling four JVC
video units independently. Each of the units can
respond to one of four codes (A, B, C or D). The
remote control is preset to send C code signals
because your unit is initially set to respond to C code
signals. You can easily modify your unit to respond to
A, B or D code signals.
1.
Press STANDBY/ON (
1/&
) on the unit to turn off the
unit with no video tape inserted.
2.
Press the number key “1” for A, “2” for B, “3” for C or
“4” for D
while
pressing ENTER ( ) down on the
remote control.
3.
Press
N/``
on the unit for over 5 seconds while the
unit is turned off. The current code appears on the
display window.
4.
Press STOP (
x
) on the remote control, the current
code on the display window changes to new code
and blinks for approximately 10 seconds.
5.
The new code setup on unit and remote is done.
Note:
If you change the batteries of the Remote Control with
A, B or D code, the remote control code is set to C
automatically. In this case, you should reset the remote
control code described above.
STANDBY/ON (
1/&
)
Number 1-4
STOP (
x
)
ENTER (
)
B/``
