1-6 (No.YD089B)
3.1.3 Remove the drive unit (See figure 5)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the front panel assembly.
(1) Disconnect the socket wire from connector
CN5302
on the
main board.
(2) Disconnect the card wire from connector
CN2201
on the
digital board.
(3) Remove the five screws
E
attaching the drive unit and
bracket.
Fig.5
3.1.4 Remove the HDMI board and digital board (See figure 6, figure 7)
• Prior to performing the following procedure, remove the top
cover and HDD.
(1) Disconnect the socket wire from connector
CN2404
on the
HDMI board.
(2) Remove the three screws
F
attaching the HDMI board.
(3) Remove the two screws
G
(
G1, G2
) attaching the HDMI
board from rear side.
(4) Disconnect the connector from
CN2401
on the HDMI board
from digital board.
(5) Disconnect the card wire from connector
CN1103
on the
digital board.
(6) Disconnect the socket wire from connector
CN1101
,
CN1102
,
CN1801
on the digital board.
(7) Remove the four screws
H
attaching the digital board.
Fig.6
Fig.7
E
Drive unit
Bracket
E
CN2201
E
E
CN5302
Main board
F
Digital board
CN2404
HDMI board
H
H
F
H
F
CN2401
CN1101
H
CN1103
CN1102
CN1801
G2
G1
Rear panel
G1 --- 0.784 N-m +- 0.078N-m ( 8.0 kgf-cm +- 0.8 kgf-cm )
G2 --- 0.25 N-m ~ 0.35N-m ( 2.6 kgf-cm ~ 3.6 kgf-cm )
Torque
Please note tightening too much.