EN
15
GETTING STARTED
MasterPage: Start_Right
GETTING ST
AR
TED
Using AC Power
Perform step
in “Charging The Battery Pack”.
NOTE:
The provided AC Adapter features automatic
voltage selection in the AC range from 110 V to
240 V.
About Batteries
DANGER!
Do not attempt to take the batteries
apart, or expose them to flame or excessive
heat, as it may cause a fire or explosion.
WARNING!
Do not allow the battery or its
terminals to come in contact with metals, as this
can result in a short circuit and possibly start a
fire.
To resume the original function of the
accurate battery power indication
If the battery power indication differs from the
actual operating time, fully charge the battery, and
then run it down. However this function may not
turn back if the battery was used for a long period
of time under extremely high/low temperature
condition or charged too many times.
To turn on the camcorder, set the Power Switch
to any operation mode except “OFF” while
pressing down the Lock Button located on the
switch.
Choose the appropriate operation mode
according to your preference using the Power
Switch and
VIDEO/MEMORY
Switch.
Auto/Manual Mode
Press
AUTO
button repeatedly to switch to auto/
manual recording mode. When manual mode is
selected, the indicator “
M
” appears on the LCD
monitor.
Auto Mode :
A
You can record using no special effects or
manual adjustments.
Manual Mode :
M
Manual recording is possible by setting various
functions
.
Operation Mode
POWER/
CHARGE lamp
VIDEO/
MEMORY
Lock Button
Power Switch
MENU
AUTO
Power Switch Position
REC:
●
Allows you to perform recording on the tape.
●
Allows you to set various recording functions
using the menus. (
OFF:
Allows you to switch off the camcorder.
PLAY:
●
Allows you to play back a recording on the
tape.
●
Allows you to display a still image stored in
the memory card or to transfer a still image
stored in the memory card to a PC.
●
Allows you to set various playback functions
using the Menus. (
VIDEO/MEMORY Switch Position
VIDEO:
Allows you to record on a tape or play back a
tape. If “REC SELECT” is set to “
/
”
pg. 34), still images are recorded both on
the tape and the memory card.
MEMORY:
●
Allows you to record in a memory card or
access data stored in a memory card.
●
When the Power Switch is set to “REC”, the
currently selected image size appears.
MANUAL
AUTO
GR-D650US.book Page 15 Tuesday, August 29, 2006 8:04 AM
