– 12 –
English
Listening to FM and AM Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes
in the previously tuned station (either FM
or AM).
• Each time you press the button, the
band alternates between FM and AM.
2
Start searching for stations.
On the unit:
Press and hold or
TUNING – for more than 1
second.
On the remote control:
Press and hold
4
or
¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop during searching, press or TUNING –
(or
4
or
¢
on the remote control).
When you press or TUNING – (or
4
or
¢
on
the remote control) briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that “MONO” appears and the MONO indicator
lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE
again so that “STEREO” appears on the diplay and the
MONO indicator goes off from the display.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 1 again.
On the unit ONLY:
1
Tune in the station you want to preset.
• See “Tuning in a Station” on the left column.
2
Press SET.
3
Press or PRESET –
to select a preset number.
4
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and
tunes in the previously tuned station
(either FM or AM).
• Each time you press the button, the
band alternates between FM and AM.
2
Select a preset number.
On the unit:
Press or PRESET –.
On the remote control:
Press the number buttons.
Ex.:
For preset number 5, press 5.
For preset number 15, press +10
then 5.
For preset number 20, press +10,
then 10.
For preset number 25, press +10, +10, then 5.
For preset number 30, press +10, +10, then 10.
TUNING
STILL
FM MODE/
PREV.
NEXT
SET
PRESET
1
2
3
4
5
6
7
8
9
10
+10
SET
PRESET
Before operating the tuner, make sure you have selected the
correct AM spacing intervals (see page 10).
EN01-12.CA-MXG65V&68V[US]_f
01.5.17, 5:07 PM
12
