JVC CA-HXZ3, Instructions Manual

Page: 10 / 47

– 7 –
1
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2
Connect the AM (MW/LW) loop antenna to the
AM LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
(MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
AM (MW/LW) antenna
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop
antenna (supplied)
1
3
Connecting Speakers
1
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (–) to (–).
3
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
• DO NOT connect more than one speaker to each
speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
2
3
Speaker cords
(black/blue)
Speaker cords
(black/blue)
Speaker cords
(black/red)
From main
right speaker
From main
left speaker
From right
subwoofer From left
subwoofer
1
2
COAXIAL
ANTENNA
AM LOOP
FM 75
AM EXT
LEFT RIGHT
MAIN
SPEAKERS
SUBWOOFERS
CAUTION: SPEAKER IMPEDANCE 6 16
EN01-08.CA-HXZ3R[B]f.p65 5/21/02, 2:10 PM 7