11
Using the Powered Subwoofer
Operating the Powered
Subwoofer
Presetting the Volume
You need to preset the volume level of this speaker (SP-
PW1000) to match those of the main speakers (SP-
FSSD1000). Once you preset the volume level, it is stored
as your reference level and the volume level of this speaker
will be able to automatically change as the volume level of
the Center Unit (CA-FSSD1000) changes.
1
Press the POWER button of the Sub-
woofer to turn on the power.
The STANDBY/ON indicator of the Subwoofer will
light in
green
.
2
Set the VOLUME of the Subwoofer in the
“MIN” position.
3
Adjust the volume of the Center Unit to
your listening level.
4
Adjust the VOLUME of the Subwoofer to
balance the volume with the main
speakers.
To turn off the Subwoofwer,
press the POWER button
to light off the STANDBY/ON indicator.
Adding the Richness to the Bass (PHASE)
If you want to add the richness more to the bass, press the
PHASE button to set it either in the “
_
REVERSE” position
or the “
—
NORMAL” position, whichever can add the rich-
ness to the bass.
Normally, the PHASE button should be set in the “
—
NOR-
MAL” position.
Automatic Operating Status On/Off
To save energy, the Subwoofer enters the Standby mode if
no (or very weak) sound signals come into the Subwoofer
for about 5 minutes. In Standby mode, the STANDBY/ON
indicator of the Subwoofer lights in red.
When sound signals come in again, the Subwoofer enters
the Operating mode and reproduces the sounds. The
STANDBY/ON indicator will light in green again.
CAUTION:
• Be sure to turn off the POWER of the Pow-
ered Subwoofer when the Powered Sub-
woofer is not in use for an extended period
of time.
INPUT Terminals
The Subwoofer has the following INPUT terminals.
INPUT(LOW-LEVEL):
Usually, the LEFT/MONO terminal is connected to the
SUBWOOFER terminal of the Center Unit with the sup-
plied signal cord. (see page 7)
VOLUME
PHASE
POWER
INPUT (LOW-LEVEL)
INPUT (HIGH-LEVEL)
STANDBY/ON
indicator
When the Center Unit CA-FSSD1000 is
not used (Using other equipment)
If an amplifier etc. to be connected does not have the
SUB WOOFER OUT terminals, the RIGHT and
LEFT/MONO terminals will be connected to the LINE
OUT-RIGHT and LEFT terminals of that unit.
INPUT (HIGH-LEVEL):
You can connect the speaker output terminals of other
amplifier etc. to these terminals.
Connect the speaker cords in parallel to the speaker ter-
minals on the amplifier etc.
• Do not use the INPUT (LOW-LEVEL) terminals and
the INPUT (HIGH-LEVEL) terminals at the same time.
LINE OUT
LEFT
RIGHT
Connecting cord
(not supplied)
Amplifier etc.
SPEAKER
LEFT
RIGHT
Amplifier
etc.
Speaker cords
(not supplied)
FS-SD1000_01E.book Page 11 Thursday, March 29, 2001 1:27 PM