E-14
CAUTION
Be sure that the dome cover is firmly at-
tached. Improper attachment could result
in the cover dropping down.
Attach the dome cover.
Set the dome cover to the unit by aligning
the 3 marks on the camera and dome
cover (I, II and III).
Adjusting the Camera Angle (Continued)
Installation and connection
E-15
English
About White-spot correction
FOCUS ADJ.
OFF
OFF
OFF
ON
ON-AGC
ON-BLC
INT
WHT.BAL.
LL
PHASE
AUTO
MANU
R
B
RESET
SPOT
CORRECTION
Others
Usage
1.
Remove the dome cover.
• Switch on the camera power supply
and wait for at least 30 minutes.
2.
Cover the lens surface using a black
sheet of paper, etc. so that light does
not enter the lens.
3.
Press and hold the SPOT CORRECTION
button on the unit for more than 2
seconds.
• White-spot correction will start.
Correction may take several seconds
for completion.
As a general characteristic unique to CCD, white spots may appear on the screen when
operating under high temperature.
In order to reduce this phenomenon, this unit is equipped with a white-spot correction feature.
Memo:
• The white-spot correction feature of this unit does not guarantee the correction of all
white spots.
Maximum correction: less than 16 ~ 32 spots
Depending on the characteristic of white spots, correction may not be possible.
• When performing white-spot correction, accurate data may not be achieved in case of
highly-detailed pixels since correction is made using the information of surrounding
pixels.
• The result of white-spot correction is maintained until the next correction is performed.
Summary of Contents for C205U - Network Camera
Page 10: ...Focus chart ...
