E-7
Regular maintenance
This unit uses consumables or components that will wear off. If a worn-out or deteriorated compo-
nent continues to be used, it may cause the unit to break down. To prevent this, perform routine
maintenance using the head-cleaning tape. With the head-cleaning tape alone, however, the entire
tape-winding mechanism cannot be completely cleaned.
Perform regular maintenance of the components as shown below.
䡵
Regular maintenance
The tasks of maintenance involved are similar to that of replacing the engine oil or tire of a car.
Depending on the number of usage hours, inspect or replace the components as follows:
Number of hours
500H
1000H 1500H
2000H 4000H
Drum assembly (including head)
䡬
䡬
䡬
䢇
䢇
Head cleaner
夡
䢇
夡
䢇
䢇
Tape guide, roller
䡬
夡
夡
䢇
䢇
Reel disk, tension bands
—
夡
—
䢇
䢇
— : Inspection
䡬
: Cleaning, inspection and
adjustment
夡
: Cleaning and inspection;
Replacement if necessary
䢇
: Replacement
Work and frequency of mainte-
nance depend on the environ-
ment and usage. The above infor-
mation serves only as a guide.
Usage Time
: You can check the drum usage time with the hour meter display.
For details, refer to page 100, “Checking the hour meter.”
Maintenance consultation
: For details on the maintenance plan and fee, consult with your
JVC-authorized service agent.
䡵
Head cleaning
• Recording or playing back with a dirty head
will result in block noise or disrupted sound.
Perform regular head cleaning to maintain su-
perior image and sound quality.
• For information on how to use the head clean-
ing tape and the relevant remarks, refer to
page 8, “Cleaning tape”.
• If the head is dusty, “HEAD CLEANING RE-
QUIRED!” will be displayed on the monitor
when this unit plays a tape.
HEAD CLEANING REQUIRED!
Block Noise
DV6000E_03-027_Eng.p65e
06/03/03, 3:28 PM
7
