Before you can operate your remote
control, you first need to install the
batteries (included).
Slide the cover on the back of the
remote down towards the bottom of
the remote control. Insert two batteries
(included) carefully noting the “+” and “–”
markings, placing the “–” end in the unit
first. Slide the cover back into place.
When you change the batteries, try to complete the task within three minutes. If you take
longer than three minutes, the remote control codes for your VCR, DVD, and/or cable
box/satellite receiver may have to be reset. See pages 23 - 26.
Quick Setup Getting Started
Step 2 – The Remote Control
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through the
available channels. To move rapidly through the channels
using JVC’s Hyperscan feature, press and hold CH+ or
CH –. The channels will zip by at a rate of five channels per
second. The right and left buttons will turn the volume up
or down. These buttons are also marked with four arrows
and are used with JVC’s onscreen menu system. To use the
onscreen menus, press the M
ENU
button.
MUTING
MENU
BACK
C.C.
VCR CHANNEL
VCR DVD
CH
CH
VOL
VOL
OK
C.C.
12
Basic Operation
Turn the television on and off by pressing the P
OWER
button at the top right corner
of the remote. If this is the first time you are turning on the TV, the interactive plug-
in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if you
need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 23 to 26 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.
T
POWER
A
VCR DVD
MULTI SC
TV CATV
LT-26WX84 Eng (with stand) 12
12/11/03, 10:00:49 AM
