41
Auto Tuner Setup
The auto tuner setup function is described on page 24 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
ENU
button
π
†
To "Tuner Setup"
√
®
To
enter
π
†
To "Auto Tuner Setup"
√
®
To enter
√
®
To choose "Cable" or "Air"
π
†
To "Scan Mode"
√
®
To choose "Auto", "STD", "HRC" or "IRC"
†
To "Start"
Press the O
K
button (Programming will take serveral minutes)
The auto tuner is finished when the message
"Programming Over !"
appears onscreen.
BACK
Back
MENU
Exit
Select
Operate
Tuner Setup > Auto Tuner Setup
Tuner Mode
Scan Mode
Air
Auto
Start
–
+
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the M
ENU
button on the side of the TV
instead of the remote control. Choose "Auto Tuner Setup" by pressing M
ENU
†
on the side
panel and enter by using the C
HANNEL
+/- (
√
®
) buttons.
Tuner Setup
LCT2275-001B-A English.indd 41
LCT2275-001B-A English.indd 41
6/14/07 10:34:20 AM
6/14/07 10:34:20 AM
