Copyright 2008, Just Add Power Cardware Co., Inc. All Rights Reserved.
Page 15 of 28
A/V Source This will put the current AV Source on the target monitor/projector.
Control Buttons
Reset Same as pressing F7 Darken, F1 AV1
Setup Used to customize WCBS Settings
Quit Used to exit the WCBS GUI.
RS232 Used to remotely control devices using ASCII or HEX commands through your PC
Matrix Buttons
The audio and video Matrix functions can operate independently. When Audio Matrix is OFF, the audio
follows the active Video source to each of the four target zones. When the Matrix is ON, the audio is
routed according to your selection.
F10 – Split Button
When SPLIT MODE is on, you can assign different outputs to each bus port as Zone A or Zone B. At the
same time, the rear projector port operates independently from the rest of the system.
Total Control Console Operation
IR Matrix
When you select an A/V source and make it active, the IR
Control switches to the associated IR port (i.e. AV1 and IR1,
AV2 and IR2). However, you can override the default and
choose to control a different IR device while the other AV
device is still active. For example, you could use this function
to queue a DVD player while the Video Camera is still being
broadcast.