Issue 2/19
www.juralco.co.nz ph (09) 478 8018
Juralco Venette™ Retractable Pleated, Insect Screen Systems
Page 27
Juralco Venette™
Retractable Pleated Insect Screens
Horizontal Window - Installation
Section 3
Horizontal Window
Packaging
Magnet
profiles
+ clips
Fig 2.1 - Mesh+ Pull bars.
Taped closed
Includes negative Magnets
mounted in Pull Bars
Cord carriers
Cord carriers
+ Spring and Block
Cord carriers preinstalled
Fig 2.3 -Complete Inner
and Outer Packs.
Identify the correct sides
before Installing
End Caps
Fig 2.2 - Cord Carriers
preinstalled
in Magnet Profiles
Pull Bars +
Mesh
Masking Tape
- Remove all the cardboard packaging from around the product. Do not to cut or mark
the insect screen with cutter or scissors.
- Ensure all parts are clean, tidy and are undamaged.
Unpacking
Installation
3 - After cleaning the Sill/Base, attach Bottom
Track to the base using the DS foam tape
1 - Assemble the Frame. 1 x Top Guide and
2 x Side Guides,using 2 x Top Guide End Caps.
2 - Screw the Top and then the Side guides to the
inside the Window frame using suitable
SS screws
Note : Top Guide and Sill/Base must be to within
10mm parallel. Any more out of parallel,
pack the Top guide back to square
Bottom Track
Top Guide End Caps
Top Guide
Side Guides
Non Spring
Cord carriers
Side
Spring
Cord carriers
Side
No Cord
visible
Cord
visible
Fig 2.3
Fully assembled
Mesh Pack
as supplied
4 - Tilt/Push the Mesh Pack up into the Top Guide
then drop onto the Bottom Track, now Vertical.
- Remove Outer Tape
- Push across and Clip the Non Spring side into
the Side Profile
Spring
Cord carriers
This side