8
4.1 Cup illumination
The cup illumination puts your coffee in a good light, making it a
treat for the eyes.
When you plug in or switch on the machine or press any key, the
cup illumination is activated for 1 minute. To switch on the cup il-
lumination, with the machine switched off, press any key (Fig. 10).
5. Adjustment of water hardness
In the coffee machine water is heated up. As a result, calcifi-
cation occurs during normal use and is indicated auto-
matically. Before using the machine for the first time the
hardness of the water used must be adjusted. Use the sup-
plied test sticks for this.
1° German hardness is equivalent to 1.79° French hardness.
The coffee machine has 5 hardness degrees which can be used and
are displayed while you are adjusting the water hardness.
The displayed information means the following:
WATER
HARDNESS ––
Water hardness function switched off
WATER
German water hardness degree 1 to 7°
HARDNESS 1
French Water hardness degree 1.79 – 12.53°
WATER
German water hardness degree 8 to 15°
HARDNESS 2
French Water hardness degree 14.32 – 26.85°
WATER
German water hardness degree 16 to 23°
HARDNESS 3
French Water hardness degree 28.64 – 41.14°
WATER
German water hardness degree 24 to 30°
HARDNESS 4
French Water hardness degree 42.96 – 53.7°
When the machine leaves the factory it is adjusted to WATER
HARDNESS 3. You can adjust another hardness. To do this,
proceed as follows:
Pull out the mains cable from the cable box on the rear side of the
coffee machine and connect the machine to mains supply.
Press the key
to switch
on
the coffee machine.
WWW.IMPRESSA-F-LINE.COM
Your coffee machine is switched to start-up position.
HELLO, MACHINE HEATING UP
PRESS MAINTENANCE
MACHINE RINSING
PLEASE SELECT
Press programming key
until you hear an acoustic signal.
FILTER NO
Press symbol
until the following message is displayed:
WATER HARDNESS 3
Press symbol
, you will hear an acoustic signal and the
hardness degree flashes.
Now, press symbols
to adjust the required hardness
degree.
Press symbol
to confirm the new settings.
WATER HARDNESS 4
Press programming key
to leave Programming Mode.
PLEASE SELECT
