approx. 35 minutes the Z5 will pump the decalcifying solution
in intervals through the Milk Nozzle, then internally into the
drawer, then through the Hot Water Spout and again into the
drawer. When the water container is empty the display will
show
TRAY / GROUNDS EMPTY
.
g. Remove the containers. Then remove and empty the drawer
and used coffee container and replace complete assembly
(Fig. 2).
h.
WATER TANK FILL
. Remove the water tank, thoroughly rinse
it and fill with fresh cold water.
i. Replace the water tank.
j.
PRESS BUTTON
. Place one container underneath the Milk
Nozzle and one container underneath the Dual Coffee Spouts
and the Hot Water Spout. Each container should have at least
an 8 oz. capacity.
k. Push the Rinse Button.
MACHINE IS DECALCIFYING
. For the
next few minutes the Z5 will pump the fresh water through the
Milk Nozzle, then internally into the drawer and finally through
the Hot Water Spout to remove all decalcifying traces.
l. At the end of the decalcifying cycle the display shows
MACHINE IS HEATING
. After a few seconds the Z5 will
automatically run a rinse cycle through the Dual Coffee
Spouts.
RINSING
.
m.
TRAY / GROUNDS EMPTY
Remove the containers and
remove and empty the drawer and used coffee container and
replace complete assembly (Fig. 2).
COFFEE READY
.
Tip: You can run a decalcifying cycle at anytime even if the
machine does not prompt you.
COFFEE READY
• Push and hold the Rotary Dial until the display shows
FILTER
.
• Turn the dial until the display shows:
MAINTENANCE
• Push the dial and select
DECALCIFYING UNIT
.
• Push the dial again.
TRAY GROUNDS EMPTY
.
Continue with step b. through l. above.
30. EMPTYING SYSTEM BEFORE TRANSPORT
This procedure is necessary to prevent water and frost damage
in case you intend to transport the machine.
• Turn the machine off with the on/off button on top of the
machine. The main power switch is still on.
• Remove the water tank.
• Place a cup underneath the Hot Water Spout and place a cup
underneath the Auto Cappuccino System.
• Push and hold the Rinse button until the display shows
SYS
EMPTY
. The Z5 will release a bit of water and steam and will
turn off automatically.
• Before transport make sure the Water Container and the Bean
Container are empty.
Please note: Use the original inside and outside carton for
transport, or you can order a custom molded, special service ship-
ping container through our customer service department ($40).
31. TIPS FOR BETTER COFFEE
Pre-warm cups.
If your cup is pre-warmed, your coffee will stay warm longer,
especially when you prepare small cups. Use the hot water
spout to pre-warm your cups.
Height adjustable coffee-spout
32.
