JA72-006 Glove Box with USB Charger
Installation and Operating Manual
Rev B
Page B2
B1
Airworthiness Approval
Airworthiness approval of the JA72-006 may require completion of a TCCA Major Modification Report per CAR
STD (AWM) 571 Appendix L, or a FAA Form 337. The sample wording for a description of the work is provided to
assist the Installing Agency in preparing Instructions for Continued Airworthiness (ICA) when installing a Jupiter
Avionics JA72-006 Glove Box with USB Charger. This sample may be modified appropriately for new
installations. It is the installer’s responsibility to determine the applicability of the method used. Installations
performed outside Canada must follow the applicable aviation authority’s regulations.
Sample Wording:
Installed the Jupiter Avionics JA72-006 Glove Box with USB Charger in [aircraft location].
The JA72-006 meets RTCA DO-160G environmental qualifications for this installation. See Section 1 of the JA72-
006 Installation Manual.
Installed in accordance with the JA72-006 Installation Manual, Revision [ ], and AC 43.13-2, Chapters 2, and 3.
The JA72-006 Installation Manual provides detailed installation instructions and wiring diagrams (Section 2, and
Appendices A and B).
Power is supplied to the JA72-006 through a 1-Amp circuit breaker.
Aircraft equipment list, weights and balance amended. Compass compensation checked and found to conform to
applicable regulations.
B2
Instructions for Continued Airworthiness
Maintenance of the JA72-006 Glove Box with USB Charger is “on condition” only. Refer to the JA72-006
Maintenance Manual. Periodic maintenance of the JA72-006 is not required.
The following sample Instructions for Continued Airworthiness (ICA) provides assistance in preparing ICA for the
Jupiter Avionics JA72-006 unit installation as part of a Type Certificate (TC) or Supplemental Type Certificate
(STC) project to comply with CAR STD (AWM) 523/527/525/529.1529 or FAR 23/25/27/29.1529 “Instructions for
Continued Airworthiness”.
Items that may vary by aircraft make and model are shown in brackets (“[ ]”) and should be filled in as
appropriate. Some of the checklist items do not apply, in which case they should be marked “N/A” (Not
Applicable).
Instructions for Continued Airworthiness, Jupiter Avionics JA72-006 Glove
Box with USB Charger in an [Aircraft Make and Model]
1. Introduction
[Aircraft that has been altered: Registration number, Make, Model and Serial Number]
Content, Scope, Purpose and Arrangement
: This document identifies the Instructions for Continued
Airworthiness for a Jupiter Avionics JA72-006 installed in an [aircraft make and model].
Applicability
: Applies to a Jupiter Avionics JA72-006 installed in an [aircraft make and model].
Definitions/Abbreviations
: None, N/A.
Precautions
: None, N/A.
Units of Measurement
: None, N/A.
Referenced Publications
: JA72-006 Installation and Operating Manual
JA72-006 Maintenance Manual
JA72-006 Operating Manual
STC/TC # [applicable STC/TC number for the specific aircraft installation]
Distribution
: This document should be a permanent aircraft record.
