Junso JS-208B, Owner'S Manual

Page: 18 / 25

18
EN
Basic settings:
1. Hold MODE + ST/SP + RESET buttons together to enter into metric/imperial systém setting
model. There are 2 lines on LCD to display „lb“ and „inch“, means imperial systém („lb“ is pound
for weight, „inch“ is inch for length). Pressing
RESET button again will display „kg“ an „cm“,
means Metric system („kg“ is weight unit, „cm“ is length unit). Press reset button again to switch
between metric system and imperial system. Press
MODE button to confirm the setting for weight
and length, then stride parameter will flash pending for setting.
2. Press RESET button to se stride, then MODE button to confirm this setting. Stride parameter
range is 30-50 cm (or 11-60 inch), default value is 50 cm (or 20 inch). Each press ( RESET ) to
add 1 unit from low to high until coming back to another circle.
3. Press MODE to enter into distance/time mode or calorie/time mode. Hold the MODE again for 2
second to enter into setting mode. The setting operation will be the same as above.
4. Press the MODE button to enter into STEP/TIME mode. In
TIME mode, press and hold the MODE button for two seconds to
reset time. The 12 hour value will flash. Use the RESET button
to make a selection between 12hour format and 24hour format.
Then press
MODE button to confirm the settings. Press RESET
button to adjust value and MODE button to confirm it.
5. All settings could be changed by pressing button MODE for 2 seconds and pressing RESET and
MODE buttons for correction.
How to set the sensitivity of sensor:
Make sure to set the sensitivity of step counting sensor before the first usage of this unit as bellow:
Wear pedometer appropriately and set to step counting mode. Try walking and remember the steps.
Compare the real steps with the counting value. If pedometer counting is more than real value, please
wrest the sensitivity button
E a little to “-“, if less value, please wrest to opposite direction. Then back to
the first step, and repeat the operation until the two values come to the same.
Check and delete STEPS/DISTANCE/CALORIES:
Press MODE to switch between steps/time, distance/time/calorie. In step/time mode, press RESET
button to clear all data (all steps, distance and calorie memories) to zero.