JUNO JKU2048 Operating Instructions Manual Download Page 8

The following table shows which ambient
temperature is correct for each climate classification:

16

Climate
classification

SN

+10 to +32¡C

+16 to +32¡C

+18 to +38¡C

+18 to +43¡C

N

ST

T

for an ambient temperature of

Panelling the door

1. Take off the door frame section opposite to the

door handle.

2. Loosen, without removing them, all remaining

screws securing the door frame.

3. Slide in the decor panel from the frameless side,

then fasten again the frame to the door including
the previously removed frame section.

Note

The overall dimensions of the decor panel must be 1
to 2 mm less than those of the door, with a maximum
thickness of 4 mm.

PR121

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.

Important
The appliance must be earthed.

The power supply cable plug is provided with a
contact for this purpose.

If the domestic power supply socket is not
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.

The Manufacturer declines all
responsibility if the above safety
precautions are not observed.

This appliance complies with the following E.E.C.
Directives:

- 87/308 EEC of 2/6/87 relative to radio

interference suppression.

- 73/23 EEC of 19.2.73 (Low Voltage
Directive)  

and subsequent modifications.

- 89/336 EEC of 3.5.89 (Electromagnetic 

Compatibility Directive) and subsequent 
modifications.

Attention!

It must be possible to disconnect the appliance

from the mains power supply; the plug must
therefore be easily accessible after installation.

Summary of Contents for JKU2048











Reviews: