JUNO JDZ9068, Operating Instructions Manual, Page: 8 / 14

18
Cleaning
Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders,
highly perfumed cleaning products or wax
polishes to clean the interior as these will
damage the surface and leave a strong
odour.
Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly.
ÒVital & frischÓ 0¡C compartment
¥ The lowest shelf, dividing the cooler compartment
from the ÒVital & frischÓ 0¡C compartment can be
removed for cleaning. To remove pull out the shelf
straight.
The cover plates above the drawers in the 0¡C
compartment can be taken out for cleaning. To
make sure fully functionality of the ÒVital & frischÓ
0¡C compartment the cover must be put back in
their original position after cleaning.
Maintenance
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its
cooling unit maintenance and recharging must
therefore only be carried out by authorised
technicians.
Defrosting
¥ Defrosting the refrigerator compartment is
automatic. The defrost water drains out through a
trough into a container at the back of the appliance,
above the motor compressor, where it evaporates.
Cakes containing cream and other kinds of pastry
products can be stored in the ÒVital & frischÓ 0¡C
compartment for 2 or 3 days.
Type of food Air humidity adjustment Storage time
Apricots, cherries
ÒhumidÓ
up to 14 days
Blackberries, currants
ÒhumidÓ
up to 8 days
Figs (fresh)
ÒhumidÓ
up to 7 days
Blueberries, raspberries
ÒhumidÓ
up to 5 days
Damsons, grapes
ÒhumidÓ
up to 10 days
When the appliance is not in use
Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
Changing the light bulb
¥ Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
supply, then replace the bulb as follows:
1. unscrew the light cover securing screws.
2. unhook the moving part by pressing it as shown
in the figure.
3. Replace the bulb by other with another with the
same charcteristics.