11
O 1 2 3
O I
Using the hood
The hoods
JDS2230 and JDS 3230
are
supplied with a three speed motor.
To get best efficiency, we suggest to use
slow speeds in normal conditions and the
highest in particular cases of strong smell
and vapour concentration.
The switching plate is fitted with two switches
one for continuous adjustment of the
ventilator (top switch) and one for
illuminating the work surface (bottom switch)
.
Note: Simply close the front panel to switch
off the hood (light and motor).
When you pull up the front panel, the hood
(light and extraction motor) switches on
again as previously set.
It is advisable to switch on the extractor
hood a few minutes before starting cooking
and then to leave it running for approximately
15 minutes afterwards to ensure that all
odours are extracted.
Attention!
The hood doesn't switch-ON if the flap is
not mounted.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Grease filter
The hood has a metal grease filter.
To clean the filter, proceed as follows:
a. Open the grid by turning locks D (Fig. 3).
b. Extract the filter V after removing the
clamps U (Fig. 15).
The metal grease filter lasts forever and
must be washed at least once a month
either by hand or in the dishwasher (60°C)
with suitable detergents.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Let the filter dry without damaging it before
putting it back into place.
Every time you clean the metal grease filter
also clean the grid with suitable detergents
without abrasive.
Charcoal filter
The active carbon filter serves to dissolve
odours from food that is cooking.
Change the filter at least once every 4
months.
It cannot be washed or regenerated.
To remove the carbon filter push the push-
buttons G inwards and pull the filter
downwards (fig. 4).
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires. Therefore, we
recommend observing these instructions.
Changing the bulbs
a. Disconnect the hood from the electricity.
b. Remove the inlet grid.
c. Always replace burnout bulbs with olive-
shaped max 40 Watt (E14) bulbs.
d. Refit the inlet grid.
— Before calling for Repair service because
the hood fails to light up, make sure the
bulbs are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents.
Never use products containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Light switch
Motor speed
selector
Summary of Contents for JDS 2230
Page 2: ...2 Fig 1 A B Fig 2 Fig 3 5 4 O 1 2 3 O I 1 18 98 1 10 123 C A 1 2 3 3 D E D E ...
Page 3: ...3 Fig 5 Fig 4 F F G G G N1 L L M M Fig 7 Fig 6 0 90 0 54 54 100 Fig 8 L N O P Q R S ...
Page 4: ...4 Fig 9 Fig 10 B B2 B1 C C2 C1 Fig 11 Fig 12 Fig 14 Fig 13 N2 N2 T T 3 H K N3 J Fig 15 U V ...
Page 12: ...LI08PA ELECTROLUX ZANUSSIHAUSGERÄTEGMBH Rennbahnstraße72 74 D 60528Frankfurt ...
