10
Use of the hood
It is advisable to switch on the extractor hood a
few minutes before starting cooking and then
to leave it running for approximately 5 minutes
afterwards to ensure that all odours are
extracted.
Use the slow speed in normal conditions and
the fast speed with heavy fumes or odours.
Electronic control panel
A – Motor OFF button
B – On button and motor speed selection
button 1 - 2 - 3 - 1 - 2 - . . . .
E – Speed 1 LED
F – Speed 2 LED and metal grease filter
saturation LED (flashes)
C – Speed 3 LED and carbon filter saturation
LED (flashes)
D – Intensive speed LED
G – Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or odours
is particularly strong (for example when
frying, cooking fish etc.). The fast speed
will run for about 5 minutes and then
return to the speed previously set
automatically (1, 2 or 3), or switch off if no
speed was selected. To turn off the fast
speed, before the end of the 5 minutes,
press button A or button B.
H – OFF lamp button
I – ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
almost 5 sec. by pulling out the plug. Then plug
it in again and try once more before contacting
the Technical Assistance Service.
Control panel with keypad.
a. "ON" indicator light
b. Light ON-OFF button
c. Motor OFF button
d. e. f. Motor speed buttons
speed 1 (d.), speed 2 (e.), speed 3 (f.)
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be
removed from the socket.
Metal grease filter
This holds back suspended grease parti-
cles.
The metal grease filter lasts forever and must
be washed either by hand or in the dishwasher
(65°C) with suitable detergents.
Let the metal filter dry without damaging it
before putting it back into place.
Hood featuring control panel with keypad
The grease filters must be washed at least
once a month.
Hood with electronic control panel
ìThe metal grease filters must be washed at
least once a month and anyhow whenever the
metal grease filter saturation led (Speed 2
LED) indicates the saturation of the filter.
This LED warns you when the metal grease
filter needs to be cleaned.
This LED flashes to warn you that the metal
grease filters must be cleaned.
Generally, these must be cleaned after 40
hours of use.
Once the grease filters have been cleaned,
GB
B
E F C D G
H
I
A
Summary of Contents for JDK9940S
Page 3: ......
