JUNO JCF178F0S1, User Manual, Page: 42 / 48

Problem Possible cause Solution
Appliance is fully loaded and is
set to the lowest temperature. Set a higher temperature. Refer
to "Control panel" chapter.
Temperature set in the appliance
is too low and the ambient tem‐
perature is too high. Set a higher temperature. Refer
to "Control panel" chapter.
Water flows on the rear plate of
the refrigerator. During the automatic defrosting
process, frost melts on the rear
plate. This is correct.
There is too much condensed
water on the rear wall of the re‐
frigerator. Door was opened too frequently. Open the door only when neces‐
sary.
Door was not closed completely. Make sure the door is closed
completely.
Stored food was not wrapped. Wrap food in suitable packaging
before storing it in the appliance.
Water flows inside the refrigera‐
tor. Food products prevent the water
from flowing into the water collec‐
tor. Make sure that food products do
not touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not
connected to the evaporative tray
above the compressor. Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set. The FastFreeze function or Shop‐
ping function is switched on. Switch off FastFreeze function or
Shopping function manually, or
wait until the function deactivates
automatically to set the tempera‐
ture. Refer to "FastFreeze func‐
tion" or "Shopping function" sec‐
tion.
The temperature in the appliance
is too low/too high. The temperature is not set cor‐
rectly. Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
The food products' temperature is
too high. Let the food products tempera‐
ture decrease to room tempera‐
ture before storage.
Many food products are stored at
the same time. Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
42 ENGLISH