JUNO JCF178F0S1, User Manual, Page: 41 / 48

Problem Possible cause Solution
The temperature in the appliance
is too high. Refer to "Door open alarm" or
"High temperature alarm".
The door is left open. Close the door.
The compressor operates contin‐
ually. Temperature is set incorrectly. Refer to "Control panel" chapter.
Many food products were put in
at the same time. Wait a few hours and then check
the temperature again.
The room temperature is too
high. Refer to "Installation" chapter.
Food products placed in the ap‐
pliance were too warm. Allow food products to cool to
room temperature before storing.
The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
The FastFreeze function is
switched on. Refer to "FastFreeze function"
section.
The Shopping function is switch‐
ed on. Refer to "Shopping function" sec‐
tion.
The compressor does not start
immediately after pressing the
"FastFreeze" or "Shopping", or
after changing the temperature. The compressor starts after a pe‐
riod of time. This is normal, no error has oc‐
curred.
Door is misaligned or interferes
with ventilation grill. The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the
door immediately after closing. Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the nearest Authorized
Service Centre.
There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
The gasket is deformed or dirty. Refer to "Closing the door" sec‐
tion.
Food products are not wrapped
properly. Wrap the food products better.
Temperature is set incorrectly. Refer to "Control panel" chapter.
ENGLISH 41