Juniper XRE200 -, Hardware Manual

Page: 32 / 188

Virtual Chassis Port LEDs on an XRE200 External Routing Engine
Each Ethernet Virtual Chassis port (VCP) on the XRE200 External Routing Engine—each VCP on the RJ-45
or SFP VCCI module as well as the native VCP (port 0)—has two LEDs.
Figure 7 on page 32 shows the VCP LEDs.
Figure 7: Gigabit Ethernet VCP LEDs on an XRE200 External Routing Engine
g020954
0 1 2 3
EX8200-XRE200
Disk Number
Slot Number
0 1
0 1 2
USB
LINK/
ACT SPD
CONSOLE MGMT 0
LINK/
ACT SPD
LINK/
ACT SPD
LINK/
ACT SPD
LINK/
ACT SPD
LINK/
ACT SPD
0
Link/Activity
LED Speed
LED
Table 10 on page 32 describes the Link/Activity LED.
Table 10: Gigabit Ethernet Port LEDs in an XRE200 External Routing Engine—Link/Activity LED
State and Description Color LED
•
On steadily—The port and the link are active, but there
is no link activity.
•
Blinking—The port and the link are active, and there is
link activity.
•
Off—The port is not active.
Green Link/Activity
The LEDs labeled SPD indicate the current speed of the port.
Table 11 on page 32 describes the Speed LED.
Table 11: Gigabit Ethernet Port LEDs in an XRE200 External Routing Engine—Speed LED
State and Description Color LED
•
Link/Activity LED is Off—port speed is 0 Mbps
•
Link/Activity LED is On steadily or blinking—port speed
is 10 Mbps
Off Speed
100 Mbps Green Speed
32