Juniper XRE200 -, Hardware Manual

Page: 31 / 188

Management Port LEDs on an XRE200 External Routing Engine
The management port (labeled MGMT) on the XRE200 External Routing Engine has two LEDs that indicate
link/activity and port status (see Figure 6 on page 31 ). The management port is set to full duplex and the
speed is set to 100 Mbps.
Figure 6: LEDs on the Management Port on an XRE200 External Routing Engine
g020953
0 1 2 3
EX8200-XRE200
Disk Number
Slot Number
0 1
0 1 2
USB
LINK/
ACT SPD
CONSOLE MGMT 0
LINK/
ACT SPD
LINK/
ACT SPD
LINK/
ACT SPD
LINK/
ACT SPD
MGMT
Link/Activity
LED Status
LED
Table 8 on page 31 describes the Link/Activity LED.
Table 8: Link/Activity LED on the Management Port on an XRE200 External Routing Engine
State and Description Color LED
•
Blinking—The port and the link are active, and there is
link activity.
•
On steadily—The port and the link are active, but there
is no link activity.
•
Off—The port is not active.
Green Link/Activity
Table 9 on page 31 describes the Status LED (administrative status).
Table 9: Status LED on the Management Port on XRE200 External Routing Engine
State and Description Color LED
•
On steadily—Administrative status is enabled.
•
Off—Administrative status is disabled.
Green Status
31