Juniper WLA Series, Hardware Documentation

Page: 29 / 92

Table 7: Site Preparation Checklist (continued)
Date Performed By For More Information Item or Task
If you are installing the access point
in a wireless LAN mesh or wireless
bridge configuration, you must
configure the access point before
deploying the access point in the
final location. To configure the
access point connection, use the
RingMaster GUI or the Mobility
System Software CLI.
See
Mobility System Software
Configuration Guide at
http://www.juniper.net/techpubs/en_US/release-independent/wireless/
information-products/pathway-pages/wireless-lan/software-80.html
.
Configure the Access Point Connection
Related
Documentation
General Safety Guidelines and Warnings on page 23
•
•
General Site Guidelines on page 17
General Site Guidelines
This topic applies to hardware devices in the WLA Series.
Efficient device operation requires proper site planning and maintenance and proper
installation of the equipment using brackets, adapters and other hardware from
installation kits.
To plan and create an acceptable operating environment for your device and prevent
environmentally caused equipment failures:
•
Keep the area around the access point free from dust and conductive material.
• Follow prescribed installation and safety guidelines to ensure that the access point is
properly installed and not at risk for causing damage to the hardware or falling to
potentially cause bodily harm.
•
Follow the prescribed environmental requirements and specifications to avoid damaging
the equipment.
• Install the device in a secure area, so that only authorized personnel can access the
device.
Related
Documentation
Environmental Requirements and Specifications for the WLA532E Access Point on
page 18
•
•
Medical Safety Compliance for WLA Series Access Points on page 25
17 Copyright © 2012, Juniper Networks, Inc.
Chapter 3: Site Preparation