Juniper TCX1000-RDM20, Hardware Manual

Page: 123 / 206

3.
Have a second person secure the front of the chassis to the rack using four mounting
screws (and cage nuts and washers if your rack requires them). Tighten the screws.
See
Figure 43 on page 109 .
Figure 43: Installing the Chassis on a Rack
g009496
Installing the TCX1000-2D8CMD in the Chassis
To install the TCX1000-2D8CMD in the chassis:
1.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
2.
Remove the blank cover by pulling the knobs of the snap latch (located on either side)
and pulling the cover out. See
Figure 44 on page 109 .
Figure 44: Removing the Blank Cover from the Module Slot
g100051
3.
Lift the TCX1000-2D8CMD and carefully align it with the slot in the chassis, as shown
in
Figure 45 on page 110 .
109 Copyright © 2019, Juniper Networks, Inc.
Chapter 17: Installing and Connecting the TCX1000-2D8CMD Modules