Juniper SSR130, Hardware Manual

Page: 42 / 88

b. Select external for Type.
4. Scroll down to Interface Addresses and select ADD.
a. Enter 2.2.2.128 for the address and select SAVE.
b. Give the network interface a Prefix of 24.
c. Assign a Gateway using your network gateway address.
5. Return to the Network Interface level (up one level).
a. Scroll down to Neighborhoods and select ADD.
b. Select internet and select SAVE.
c. Under Basic Information, verify that the Topology is Spoke.
Configure the LAN Interface
1. Return to the Node level of the configuration (up three levels).
2. Scroll down to Device Interfaces and select ADD.
a. Name the Device Interface _lan1_.
b. Select Ethernet for Device Interface Type.
c. Enter the PCI address of the interface to be used as the LAN interface under PCI Address. To identify
the PCI Address, refer to [Identify Interface PCI Addresses]
(intro_system_reqs.md#identify-interface-pci-addresses).
3. Scroll down to Network Interfaces and select ADD.
a. Name the interface _lan1_.
b. Select External for Type.
c. Assign _corp_ as the Tenant.
4. Scroll down to Interface Addresses and select ADD.
a. Enter the address 192.168.64.1.
b. Give the network interface a Prefix of 24.
Create a Service Route
1. Return to the Router level (up four levels).
2. Scroll down to Service Routes and select ADD.
a. Name the Service Route _internet-route_ and select ADD.
b. Select internet as the Service Name.
c. Under Service Route Type, select Service Agent.
42