Juniper SRX4100, Hardware Manual

Page: 51 / 134

CHAPTER 8
Pinout Specifications
• Management Port Connector Pinout Information for an SRX4100 Services
Gateway on page 35
•
Console Port Connector Pinout Information for an SRX4100 Services
Gateway on page 36
Management Port Connector Pinout Information for an SRX4100 Services Gateway
The port on the front panel labeled MGMT is an autosensing 10/100/1000-Mbps Ethernet
RJ-45 receptacle that accepts an Ethernet cable for connecting the services gateway to
a management LAN (or other device that supports out-of-band management). Two
LEDs on the port indicate link activity on the port and the administrative status of the
port.
Table 21 on page 35 provides the pinout information for the RJ-45 connector for the
management port. An RJ-45 cable, with a connector attached, is supplied with the services
gateway.
Table 21: Management Port Connector Pinout Information
Signal Pin
TX+ 1
TX- 2
RX+ 3
Termination network 4
Termination network 5
RX- 6
Termination network 7
Termination network 8
35 Copyright © 2017, Juniper Networks, Inc.