Juniper SRX 5800, Hardware Manual

Page: 265 / 536

To install the craft interface (see Figure 112 on page 266 ):
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Grasp the craft interface with one hand and hold the bottom edge of the craft interface with the other
hand to support its weight.
3. Orient the ribbon cable so that it plugs into the connector socket. The connector is keyed and can be
inserted only one way.
4. Align the bottom of the craft interface with the sheet metal above the card cage and press it into place.
5. Using the Phillips (+) number 2 screwdriver tighten the screws on the left and right corners of the craft
interface faceplate.
6. Reattach any external devices connected to the craft interface.
Figure 112: Installing the Craft Interface
1
0
1
0
1
0
1
0
1
0
1
1
0
0
1
0
1
0 1
0
g004040
OK
0
FAIL
ONLINE
OK
1
FAIL
ONLINE
OK
2
FAIL
ONLINE
OK
3
FAIL
ONLINE
OK
4
FAIL
ONLINE
OK
5
FAIL
ONLINE
OK
0
FAIL
ONLINE
MASTER
ONLINE
OFFLINE
RE0
FAN
PEM
1
0
0 1 2 3
RE1
OK
1
FAIL
ONLINE
OK
7
FAIL
ONLINE
OK
8
FAIL
ONLINE
OK
9
FAIL
ONLINE
OK
10
FAIL
ONLINE
OK
11
FAIL
ONLINE
OK
2 6
FAIL
ONLINE
ACO/LT
YELL OW ALAR M
RED ALAR M
NC NO C NC
NO C
Connecting the Alarm Relay Wires to the SRX5800 Services Gateway Craft Interface
Before you begin connecting the alarm relay wires to the services gateway and an alarm-reporting device
:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 505 .
Ensure that you have the following available:
•
ESD grounding strap
266