Juniper QFX5100, Hardware Manual

Page: 185 / 256

Figure 36: Slide Mounting Rail onto the QFX5100-96S Rear Mounting
Blade
8.
Continue to support the switch while sliding the rear mounting-blades into the channel
of the side mounting-rails and securing the blades to the rack. Use the four mounting
screws (and cage nuts and washers if your rack requires them) to attach each blade
to the rack. (Use eight front-mounting screws for the QFX5100-96S.) Tighten the
screws. See
Figure 37 on page 167 .
Figure 37: Slide Mounting Blade into 1 U Mounting Rail
9.
Ensure that the switch chassis is level by verifying that all the screws on the front of
the rack are aligned with the screws at the back of the rack.
Related
Documentation
Rack-Mounting and Cabinet-Mounting Warnings on page 130
•
•
Connecting AC Power to a QFX5100 Switch on page 173
•
Connecting Earth Ground to a QFX5100 Switch on page 172
Virtual Chassis Fabric Installation Overview
For best results, ensure you review and understand the Virtual Chassis Fabric (VCF)
configuration options. These configuration options are explained in
Understanding Virtual
Chassis Fabric Configuration . Do not interconnect the switches with cables until directed
in the procedure.
167 Copyright © 2014, Juniper Networks, Inc.
Chapter 16: Installing the QFX5100 Device