Juniper MX480, Hardware Manual

Page: 231 / 420

Replacing the MX480 Cable Management Brackets
To remove the cable management brackets (see Figure 86 on page 231 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Loosen the captive screws on either side of the chassis.
3.
Remove the cable management brackets.
To install the cable management brackets (see Figure 86 on page 231 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Position the on the front sides of the chassis.
3.
Insert the tabs into the slots.
4.
Tighten the screws completely.
Figure 86: Removing the Cable Management Brackets
g004260
Screws
Slot
Tab
231 Copyright © 2019, Juniper Networks, Inc.
Chapter 4: Maintaining Components