Juniper MX2010, Hardware Manual

Page: 476 / 825

NOTE: The card-cage cable manager is permanently installed onto the MX2010 system
chassis, and cannot be removed.
•
Standard and Extended
NOTE: The MX2010 comes equipped with a standard lower cable manager. The extended
lower cable manager can be ordered from Juniper Networks.
•
Standard DC and Extended DC
1.
Removing the MX2010 Standard Cable Manager | 460
2.
Installing the MX2010 Standard Cable Manager | 461
3.
Removing the MX2010 Standard DC Cable Manager | 462
4.
Installing the MX2010 Standard DC Cable Manager | 463
Removing the MX2010 Standard Cable Manager
To remove the standard cable manager (see Figure 226 on page 461 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the two captive screws on the lower cable manager cover, and remove it.
3. Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the lower cable manager.
4. Grasp the lower cable manager, and pull it straight out from the studs on the front of the chassis.
460