Juniper MX2010, Hardware Manual

Page: 262 / 825

Figure 90: Removing a DC Power Supply Module (240 V China) Before Installing the MX2000 Router
8
6
g100409
Removing the Fan Trays Before Installing an MX2010 Router
To remove the upper and lower fan trays (see Figure 91 on page 246 and Figure 92 on page 246 ):
NOTE: The fan trays are interchangeable and are hot-insertable and hot-removable.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
2. Loosen the two captive screws on each side of the fan tray access panel and open the panel.
3. Loosen the two captive screws on the fan tray faceplate.
4. Press and hold the latch while simultaneously pulling the fan tray out approximately 1 to 3 in. Place
one hand under the fan tray for support, while pulling the fan tray completely out of the router.
245