JunosE 11.1.1 Release Notes
52
Resolved Known Problems
Copyright © 2010, Juniper Networks, Inc.
z
VLAN bulk configuration cannot be removed after certain CLI sequences. [Defect ID
90214]
z
L2TP tunneled subscribers unable to browse the internet. [Defect ID 90333]
z
LM10A Memory leaking after flapping DHCP/PPP subscribers along with Link Flap.
[Defect ID 90603]
z
WAN SPI4 drops due to missing start or end of packet should cause a panic. [Defect
ID 90611]
z
LM10A Memory leak due to PPP/DHCP subscriber flap. [Defect ID 90570]
z
LM10A crash - SRA-2048 - file: ic1Detector.cc line: 1013 message:
Ic1Detector::requestRecovery executed forced IC crash. [Defect ID 90704]
z
ICR redundancy: during ICR switchover, E series sends PADT also on interfaces which
are not affected by the switchover. [Defect ID 90825]
z
LM10A: Memory leak on "luCodeBranch code branch representations" when
classifier-group "*" references a rate-limit-profile. [Defect ID 90737]
z
LM10A reset due to sraPanic 2048. [Defect ID 90939]
z
The DoS protection egress rate is not accurate for the ES2 10G LM or the ES2 10G
Uplink LM. [Defect ID 86925]
Hardware
z
ERX doesn't update ARP cache when Gratuitous ARP Reply/Response is received for
an IP which already exist in ERX ARP table [Defect ID 88936]
z
E320 does not discard DHCPv6 Solicit message and rebind message. [Defect ID
90798]
z
E320-output value of "lease timer" has HEX cases and DECIMAL cases as seen in
dhcpv6LsGeneral [Defect ID 90799]
z
LM10 reset type: exception 0x68616c74 (halt) [Defect ID 90100]
z
Line module crashes when performing SNMP set operation - file: ethernet.cc line:
2687 task: scheduler. [Defect ID 90708]
z
LM10U reset type panic file: aptationLayer.cc line: 3159
Hw2MplsAdaptationLayer::setEgressDirectNextHopLabel [Defect ID 90732]
z
ERX (with LAG interface) does not send correct NasPortID to SAE instead of dsi
interface. And not as the major interface. [Defect ID 90208]
z
SSCC does not send "serviceBundle" attribute to SAE. [Defect ID 90275]
z
ERX didn't response to L2TP control packet during ISSU. [Defect ID 90336]
z
LM4 reset type: panic file: thernetHF1072.cc line: 204 task: scheduler
Ethernet::autoConfigVlanReceive [Defect ID 90857]
z
Line card redundancy is broken when a primary line card is STUCK IN BOOTING state
and the router is reloading. [Defect ID 90898]
z
LM4: reset type: panic; task: scheduler; file: vsm.cc - Vsm::addAciData [Defect ID
90723]