Juniper Junos Space JA1500, Hardware Manual

Page: 22 / 210

NOTE: From Junos Space Network Management Platform Release 14.1R2
onward, you can configure Junos Space Ethernet interfaces with only IPv4
addresses, or both IPv4 and IPv6 addresses.
Junos Space supports managed devices based on the IP address type (that is, the IPv4
or IPv6 address) configured for the device management interface. You can configure an
IPv4 or IPv6 address for the device management interface. If the device management
interface is not configured, the IP address type of the node management interface (eth0)
is considered for communication with managed devices.
Table 6 on page 8 details the
support matrix for IPv4 and IPv6 address configurations on the device management
interface.
Table 6: Matrix for IP Address Versions Supported on Devices
IP Address of
Managed Devices
Supported by Junos
Space eth3 eth0
IPv6 Address IPv4 Address IPv6 Address IPv4 Address
IPv4 Not Configured Not Configured Not Configured Configured
IPv4 and IPv6 Not Configured Not Configured Configured Configured
IPv4 Not Configured Configured Not Configured Configured
IPv4 and IPv6 Configured Configured Not Configured Configured
IPv6 Configured Not Configured Not Configured Configured
IPv4 and IPv6 Configured Configured Configured Configured
You can use the Ethernet interfaces as follows:
•
eth0—Use the eth0 interface to configure the virtual IP (VIP) address of a fabric and
the IP address of the node as well as to access the managed devices. The VIP address
and the IP address of the node should be on the same subnet.
The eth0:0 subinterface provides access to the Junos Space Network Management
Platform GUI. You can access the GUI by using the VIP address of the fabric.
• eth1—Use the eth1 interface as an administrative interface of a Junos Space node. Use
SSH to access a Junos Space node through this interface. The eth0 interface and the
eth1 interface can be on different subnets.
If you configure eth1, you cannot access the Junos Space nodes using the eth0 interface.
You can access the CLI of the Junos Space node only through the eth1 interface.
Copyright © 2018, Juniper Networks, Inc. 8
JA2500 Junos Space Appliance Hardware Guide