Juniper Archer 2, Owner'S Manual

Page: 81 / 135

Chapter 8 3G Data Modem
77
4. You may be asked to provide the modem’s model
number. This number allows the carrier to verify this
modem as one of its approved models. If asked for this
by the carrier, it is a Juniper Systems Archer 2.
Install the SIM Card
To insert or remove a card follow these steps:
1. Power off the handheld by holding the power button
until the Power Button menu appears and selecting
Power Off . Ensure that your unit is not plugged in to
external power.
2. The SIM card slot is located in the battery compartment.
Loosen the screws to the door and remove it.
CAUTION:
Do not use a micro SIM adapter. The adapter
can get stuck and damage the slot.
3. Remove the battery pack.
CAUTION: The Archer 2 is not sealed against water and
dust when the battery door is not installed.
4. An image on the battery compartment label shows the
correct location and orientation for the mini SIM card.
Pull out the SIM card tray. Place the card onto the tray
and push the tray in until it catches.
To remove the SIM card, pull the tray open and remove
the card. Push the empty tray in until it catches.
5. Replace the battery pack, and attach the battery door.
6. Power on the Archer 2.
Note: If the modem was on before shutting the Archer
2 down to insert the SIM card, you are prompted to
configure the data connection when you reboot. See
!
!