Jungle Jim’s Accessory Products, Inc. 550 O’Byrne Avenue, Louisville, KY 40223
1-888-844-JIMS & WWW.JUNGLEJIMSAP.COM
1BH
Instructions, Rev. 12.10.19
5. Slide the tri-glide to the center of the strap.
6. Insert both ends of the strap through the left slot on the male
buckle.
7. Insert both ends of the strap over and
through the right slot of the male buckle.
8. Insert both ends of the strap up and through the left side of the tri-
glide.
(This is the same tri-glide you assembled in steps 3-5). Repeat through
the right side of the tri-glide.
9. Right side is now complete.
10. Repeat steps 1
– 8 for the left side using the female buckle.
.
Installation
TOOLS REQUIRED: Drill with a 10mm drill bit, 17mm and 14mm wrench.
1. The blower pole can be positioned on the trailer to suit your space needs or requirements; however, the bottom
figure illustrates mounting on the passenger side of the trailer. We recommend that the blower post be mounted so
that the blower is facing into the wind. Once a suitable location is found, mark and drill a 10mm hole through the top
trailer rail and one more hole through the bottom rail directly below the hole in the top rail.
2. Attach the Blower Holder assembly to the trailer using 1 (#13) M10*65mm hex cap screw at the top, 1 (#16)
M10*25mm hex cap screw at the bottom, two (#14) M10 flat washers (for the top) and two (#10) M10 nylon lock nuts
as shown.
Adjust the height of the pole so that the weight of the lower blower will be resting on the trailer rail
and not only on the hook
. Tighten the hardware securely.
