Jungheinrich ESE 533, Operating Instructions Manual

Page: 76 / 133

7 Optional equipment
7.1
Keypad (CanCode) (
o
)
7.1.1 Code lock
The code lock allows a user or group of users to assign an individual user code.
Travel programs can also be assigned to the individual user codes. The user code is
configured with a master code and is described in the following sections in this
chapter.
When you have entered the valid user code the truck will be operational. The truck
will be able to perform travel, steering and hydraulic operations.
When you have entered the valid master code the truck will be switched on. Travel
operations are inhibited. The truck will be able to perform steering and hydraulic
operations. The code lock is in programming mode. When you enter one of the
following parameters the settings in the code lock can be changed.
Parameter Description
0-0-0
– Change master code
(see page 79)
0-0-1
– Add user codes
(see page 81)
0-0-2
– Change a user code
(see page 83)
0-0-3
– Delete a user code
(see page 85)
0-0-4
– Delete all user codes
(see page 87)
0-1-0
– Switch on the truck automatically
(see page 89)
0-2-4
– Assign travel programs to the user codes
(see page 91)
Newly supplied trucks have the code indicated on a sticker. When using the truck for
the first time change the master and user codes and remove the sticker.
– User code factory setting: 2-5-8-0
– Master code factory setting: 7-2-9-5
Z
When allocating the codes, ensure the rider trucks are given a different code than
pedestrian trucks.
76
02.21 en-GB