7.1.5
Add operator code
Requirements
– To prepare the truck for operation, see page 78.
Procedure
• Press the O key (116).
• Enter the valid master code with the digit keys.
When you enter the valid master code the LED
(115) flashes green.
• Enter the parameters 0-0-1 with the digit keys.
• Confirm with the SET key (114).
The LEDs (112,115) flash green.
• Enter the new user code with the digit keys.
Z
The length (4-6 digit) of the new user code must be the same as that of the
previously entered master code. The new user code must also be different from
the existing master code.
• Confirm with the SET key (114).
The LEDs (113,115) flash green.
• Enter the new user code again with the digit keys.
• Confirm with the SET key (114).
Wait until the LED (115) flashes green. The setting is saved.
• Press the O key (116).
The truck is switched off and the LED (115) is lit red.
• Check the new user code:
• Switch on the truck with the new user code, see page 78
After entering the valid user code the LED (115) lights up green, the travel
program setting is shown by the illumination of the corresponding LEDs
(111,112,113) and the truck is switched on.
• Press the O key (116).
The truck is switched off and the LED (115) is lit red.
114
111
112
113
116
115
81
02.21 en-GB
Summary of Contents for ESE 533
