1007
.GB
E 20
5.4
Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see section 5.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (
o
)). If in doubt, cancel the setting by pressing the
o
-key (26).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without a display instrument (CANDIS (
o
)):
– Enter the three digit parameter number, confirm with the Set key (22).
– Enter the setting according to the parameter list or change and confirm with the Set
key (22).
Z
If the entry is incorrect, the LED (23) of the
o
key (26) goes red. If you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the
o
key
(26).
Display instrument
(CANDIS)
LED (21)
o
key
LED (23)
Key 1
LED (24)
Key 2
LED (25)
Key 3
Service hours
are displayed
284
.
0
Green
Flashing
Off
Off
Off
1007
.GB
E 20
5.4
Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see section 5.1).
F
Safety notes for trucks with indicator instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel .
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (
o
)). If in doubt, cancel the setting by pressing the
o
-key (26).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without a display instrument (CANDIS (
o
)):
– Enter the three digit parameter number, confirm with the Set key (22).
– Enter the setting according to the parameter list or change and confirm with the Set
key (22).
Z
If the entry is incorrect, the LED (23) of the
o
key (26) goes red. If you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the
o
key
(26).
Display instrument
(CANDIS)
LED (21)
o
key
LED (23)
Key 1
LED (24)
Key 2
LED (25)
Key 3
Service hours
are displayed
284
.
0
Green
Flashing
Off
Off
Off
Summary of Contents for ECE 220
