Jungheinrich AMW 22, Operating Instructions Manual

Page: 62 / 112

4.7.3 Operation
Z
After the load is raised, the display shows the gross value of the weighed weight.
Before each weighing operation, make sure that the system is unloaded and is free
to move. The weighing system has an automatic zero correction and automatically
compensates for small variations in the zero point. For larger variations in the zero
point, the correction must be performed manually using the 0/T key (35).
The weighing system offers the facility to make manual allowances for tare weights
and to track changes in the net weight:
33
34
31 32
35 36 37 38
Procedure
• Raise the load.
• Press the 0/T key (35). The display indicates zero. The NET segment (31) shows
the activated tare weight.
• Loading or unloading the net load.
Z
The net value of the weighed weight is displayed. On unloading, the a negative value
is shown for the net weight.
Performing a zero correction in the unloaded condition causes the system to return
to the standard weighing mode. A tare weight can be entered manually, in either the
loaded or unloaded condition. Tare weights higher than the first weight range (in the
standard version up to 200 kg) will not be accepted and will lead to the display
message HELP 4.
Checking the current tare weight:
Procedure
• Press the ENTER key (36). The most recently used tare value will appear. The
segment on the right side will flash.
• To continue to use the displayed value, keep the Confirm key (35) pressed for
three seconds.
To input a new tare weight:
62
11.19 en-GB