63
62
5. Restart / set-up
After changing the battery, the watch is restarted automatically. After inser-
ting the battery, the minute hand and the hour disc will move to the 12.00
o'clock position and the watch commences with reception of the signal. The
LC display is switched off during this process. After a few minutes and follo-
wing successful reception, the watch displays the correct time automatical-
ly.
x
After successful reception of the DCF77 signal, German local time is
displayed, the reception indicator for DCF77 is activated in the LC display
and the date is given with the weekday in German.
x
After successful reception of the WWVB signal, Pacific Standard Time is
displayed, the reception indicator for WWVB is activated in the LC display
and the date is given with the weekday in English.
x
After successful reception of the JJY40 or JJY60 signals, Japanese local
time is displayed, the reception indicator for JJY40 or JJY60 is activated in
the LC display and the date is given with the weekday in English.
If the watch is not able to receive a signal because the distance to a trans-
mitter is too great, the receiving process is aborted. However, every 6 hours
your Junghans Worldtimer Chronograph will automatically check if recep-
tion is possible. A manual attempt at picking up a signal is possible at any
time by using a transmitter call.
Should none of the attempts at picking up a signal be successful, the watch
allows you to set the time to the precise second (so-called manual start). The
watch then performs like a quartz watch.
5.1 Manual start
After an unsuccessful restart, during a restart or in the ”
RC/OF
” mode during
stays abroad, the manual start can be activated to set or correct time manu-
ally. If you are operating your Junghans Worldtimer Chronograph in the
manual start mode, it will automatically attempt to pick up a signal every
6 hours, and, if successful, will cancel the programmed time and replace it
with the transmitted time. Should you be in another time zone, this does
however mean, that the time displayed will be that of the transmitted time
zone. To avoid this, you can select the the ”
RC/OF
” mode.
5.1.1 Manual setting of time
After the minute hand and the hour
disc have reached the 12.00 o'clock
position following a restart,
press the T1 ”MODE” button repeatedly
until you reach the display date/
seconds.
Now press the T2 ”SET” button for > 3
seconds and the hour display starts to
flash.
T1
T3
T2
T5
Summary of Contents for Worldtimer Chronograph
Page 1: ...Worldtimer Chronograph...
