Presence detector
Adjustable buttons IR remote control
Button
Function
´
Increasing sensitivity
²
Reducing sensitivity
³
Resetting sensitivity to presetting
Ê
Function block 1: Brightness threshold 10 lx
Ë
Function block 1: Brightness threshold 50 lx
Ì
Function block 1: Brightness threshold 150 lx
Í
Function block 1: Brightness independent op-
eration
É
Function block 1: Set current brightness as
brightness threshold
10 SEK, 30 SEK, 2 MIN, 5 MIN, 30 MIN
Function block 1: Extend minimum run-on-time
(10 seconds) by the selected value
START, STOP
Function block 1: Extend minimum run-on-time
(10 seconds) individually
Set-up buttons of IR remote control
Button
Function
Ù
Walking test – Check detection field
Ú
Reset sensitivity, brightness threshold and
run-on-time to presetting. Press for at least 3
seconds
Operation with IR remote control
If enabled, function block 1 can be operated manually by remote control. In manual operation,
brightness and motion detection for function block 1 are switched off until automatic mode is re-
set.
￭
Switch on, e.g. light: Press the
¿
button.
￭
Switch off, e.g. light: Press the
Á
button.
￭
Set automatic mode: Press the
À
button.
Manually changing settings with IR remote control
If enabled, individual settings for function block 1 can be changed during operation using a re-
mote control.
Sensitivity:
￭
Increase sensitivity: Press
´
button.
￭
Decrease sensitivity: Press
²
button.
￭
Recall set sensitivity again: Press
³
button.
The manual adjustment of sensitivity by the adjuster Sens. (6) is overwritten by the IR-re-
mote control and vice versa.
Brightness threshold:
￭
Change brightness threshold: Depending on requirement, press
Ê
button,
Ë
button,
Ì
button or
Í
button.
￭
Set current brightness as brightness threshold: Press
É
button.
Run-on-time: The preset run-on-time of 10 seconds can be extended individually.
4 / 11
82585623
23.07.2019
j0082585623
