Turn
lux
adjuster in
3
direction (see Calibrating the brightness).
Switched off via extension.
Switch on via extension.
Presence detector switches on without any detectable motion
Interference sources in the detection area.
Pay attention to interference sources, e.g. heating, ventilation, air conditioners, cooling light
bulbs in the detection area.
Possibly limit detection area with the push-on cover (see Limiting the detection area).
Presence detector does not switch off even when there is a great deal of extraneous
light.
The brightness value setting is too high.
Turn
lux
adjuster in
2
direction (see Calibrating the brightness value).
Presence detector switches off, even though people are present and the brightness is
too low
Detection problem, the surface to be monitored is not in the detection area, or furniture or pillars
are in the way.
Use an additional presence detector (see Connecting presence detectors in parallel).
Run-on time too short. Motion of persons is not detected.
Extend run-on time using
time
adjuster (see Setting the run-on time).
Presence detector switches on and of constantly
time
adjuster is set to
test
.
Set run-on time using
time
adjuster (see Setting the run-on time).
Presence detector switches off briefly and then on again immediately
Brightness drops below the brightness value setting after switch-off.
Turn
lux
adjuster in
3
direction (see Commissioning section)
6.3 Warranty
We reserve the right to make technical and formal changes to the product in the interest of
technical progress.
We provide a warranty as provided for by law.
Please send the unit postage-free with a description of the defect to our central customer
service office.
ALBRECHT JUNG GMBH & CO. KG
Volmestraße 1
58579 Schalksmühle
Telefon: +49.23 55.8 06-0
Telefax: +49.23 55.8 06-2 04
[email protected]
www.jung.de
Service Center
Kupferstr. 17-19
44532 Lünen
Germany
8/8
82542823
J:0082542823
18.09.2012
Light Management
Presence detector universal
