eNet radio DALI gateway 1-gang mini
Parameters
Setting options, Basic setting
Explanations
ters. The device is switched
immediately when the Prog
button is pressed.
Manual switch-off of the run-
on time
On, Off
Basic setting: Off
Allows manual switch-off of a
running run-on time. If the
parameter is switched off,
then a switch-off command
will also switch the actuator
on. Only visible if a run-on
time was set.
Operating hours
0...65535
Basic setting: Current value
The time is counted during
which the load is physically
switched on.
This parameter can be reset
to "0", for example after ex-
changing the load.
The Reset button is used to
reset the counter to "0". The
device must be programmed
to apply the change.
Extended channel settings
Parameters
Setting options, Basic setting
Explanations
Operating mode
Normal operation
Continuous on
Continuous off
Basic setting: Normal Opera-
tion
see Device and channels
Manual commissioning
On, Off
Basic setting: On
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Local Operation
On, Off
Basic setting: On
Blocks the output for operation
using the Prog button.
Behaviour on voltage return
On
Off
Last value
Configured brightness
Basic setting: Off
Defines the behaviour of the
output after voltage return.
Brightness on voltage return
0...100 %
Basic setting: 100 %
Brightness value, set by the
output after voltage return
(mains voltage). The para-
meter "Behaviour after voltage
return" must be set to "Con-
figured position".
Note: If the value is above the
set maximum brightness or
below the minimum bright-
ness, then the system will
switch to the appropriate limit
value.
9 / 13
82580933
22.08.2019
J0082580933
