The button is connected to the radio transmitter. The button and radio transmitter exit the
programming mode automatically.
i
If the status LED of the button flashes 3 times at 1-second intervals for approx. 5 seconds,
then the programming operation was not successful. All the memory locations in the
button or radio transmitter are occupied.
i
All On and All Off buttons of a radio transmitter are connected to the actuator automatically
as soon as the first connection to a radio transmitter takes place. Scene buttons must be
connected separately.
Disconnecting connection to a radio transmitter
o
Carry out the same steps as when connecting (see Connecting to radio transmitter).
The status LED (4) flashes quickly for 5 seconds. The button is disconnected from the
radio transmitter. The button and radio transmitter exit the programming mode
automatically.
i
If there several connections or scene buttons for a radio transmitter, all connections must
be disconnected individually.
i
All On and All Off buttons of a radio transmitter are disconnected automatically as soon as
the last connection to the radio transmitter is disconnected. Manual disconnection is not
possible.
Resetting button to the default setting
All connections to radio transmitters are disconnected and parameters are reset to default
setting.
i
The connections in the radio transmitters are preserved and must be deleted separately.
Load is switched off.
o
Press button over the entire surface for at least 20 seconds.
i
Switch inserts switch the load on until the Status LED flashes.
The status LED flashes after 4 seconds. After 20 seconds the status LED flashes faster.
o
Release the button and press it briefly and fully once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The button is reset to default setting.
6 Appendix
6.1 Technical data
Ambient temperature
-5 ... +45 °C
Radio frequency
868.0 ... 868.6 MHz
Transmitting range in free field
typ. 100 m
Transmission capacity
max. 20 mW
Receiver category
2
6.2 Parameter list
The device parameters can be changed with the eNet server:
Device and channels
Parameters
Setting options, Basic
setting
Explanations
4/15
32582723
J0082582723
27.04.2017
eNet radio centre plate
