Light Management
Touch sensor module AC/DC 24 V
Ref.-no.:
2224
TSM,
2236 TSM, 2248 TSM
4. Installation
•
Fit the supporting ring (1) in the correct position on a flush-mounting
box (observe the TOP marking).
•
Place the decorative frame (2) on the supporting ring.
•
Connect the touch sensor module (3) to the 8- channel relay station
and place it on the supporting ring (see table above).
•
Schließen Sie das Tastsensor-Modul (3) an die Relais-Station
8fach an und stecken Sie es auf den Tragring (siehe Tabelle oben).
•
Fasten the touch sensor module with the plastic screws supplied (4)
on the supporting ring. The screws are intended as a protection
against removal or theft. Tighten the plastic screws only lightly !
•
Fit the covers (5): Place the covers one by one on the touch sensor
module. The arrangement of the covers is shown in FIG A. Make
sure the cover fits properly (observe the marking TOP on the
inside) and snap it onto the device by a brief press.
Fig. C
4.1. Label covers
Fig. D
3
