Jumpking JK13S017, User Manual

Page: 18 / 22

straight enclosure pole(12)
Lay a straight enclosure pole(12) and a curved
enclosure pole(13) with plastic cap on the ground.
Make sure that the straight enclosure pole(12) is
oriented so the small holes are in position shown.
Slide a foam sleeve(16) onto each of the tubes;
note that the ends of the straight enclosure
pole(12) should not be covered.
Insert the straight enclosure pole(12) into the
curved enclosure pole(13). Tighten a self-tapping
screw(11) into the small hole in the poles(12 &
13).
Assemble the remaining straight enclosure
pole(12), curved enclosure pole(13), and foam
sleeve(16) in the same way.
Insert the end of straight enclosure pole(12 & 13)
into the hole of T-cowelded tube(4).
Attach the other three straight enclosure poles(12
& 13) in the same way. See inset drawing.