8
SERVICE, STORAGE AND TRANSPORTATION
If your unit receives a sharp blow or is damaged in another way, have it checked by
a qualified service person. Only identical OE replacement parts should be used in the
repair of the product. This will ensure that the safety of the product is maintained.
When storing the unit, disconnect output leads from unit and return all components to
zipper case for protection. Do not expose the product to fire or excessive temperatures
above 130˚C/265˚F, which may cause explosion or other harm.
Care should be taken in the transport of your jump starter to follow safe practices.
Always transport the unit in its storage case with output leads disconnected. Care
should be taken to avoid crushing or puncturing the unit or exposing it to fire or
temperatures above 130˚C/265˚F.
TROUBLESHOOTING
Problem:
I charged the unit when the % charged display indicated that the unit’s
charge was low, but after several hours, there is no change in status.
Answer:
Suspect a faulty charger.
Problem:
While charging, the % charged display indicates full charge has been
reached. But, when the unit is remove from the charger and Status Button
pressed, the unit appears to not be charged.
Answer:
Suspect a battery problem.
QUESTIONS & ANSWERS
Question:
How many jump starts can a fully charged unit provide before needing to
be recharged?
Answer:
1 to 20. Factors impacting this answer are temperature, the general
condition of the vehicle being jump started, the engine type and size of
vehicles being jump started and more.
Question:
Can the battery in the unit be replaced?
Answer:
No, the battery connections inside the unit make it impossible to replace
the battery.
Question:
What is the ideal in-use temperature for the jump starter?
Answer:
Room temperature. It will also operate at low and high temperatures,
however its capacity could be reduced. For instance, high heat will
increase self-discharge of the unit’s battery.
Question:
I have a regular 10 amp battery charger, can I use it to recharge the unit?
Answer:
No, only the supplied AC adapter should be used.
Question:
After jump starting, can I leave the unit hooked to the battery to recharge
the jump starter while the engine is running?
Answer:
No. Attempting to recharge the jump starter by this method is not possible.
